Datalogic DS4300 Instrukcja Instalacji Pobierz pdf (Strona 18)

C-BOX 100

2.4.2 System Wiring

The connection and wiring procedure for C-BOX 100 is described as follows:

1) Open the C-BOX 100 as described in paragraph 2.2.

2) Verify that the C-BOX 100 power switch is off (see Figure 6).

3) Unscrew the compression connectors and pass all the system cables

through them into the C-BOX 100 housing.

4) To connect the power and input/output signals:

• Prepare the individual wires of the system cables by stripping the

insulation back approximately 1 cm.

• Using a device such as a screwdriver, push down on the lever directly

next to the clamp (see Figure 8).

• Insert the wire into the clamp and release the lever.

The wire will now be held in the spring clamp.

Figure 8 - System Cable Connections

The wiring used can be solid or stranded but must meet the following specifications.

All positions: 24 - 16 AWG 0.2 - 1.5 mm²

The C-BOX 100 spring clamp connector pinouts are indicated in the following table.

Refer to the scanner Installation Manual for details.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25

Brak uwag

Datalogic DS4300 Instrukcja Instalacji Strona 18