Datalogic Laser Barcode Reader DS4600A-2XX5 Instrukcja Instalacji Pobierz pdf (Strona 48)

DS6300

2.3.6 Power Supply

The supply voltage of a single scanner must be between 15 and 30 VDC.

Datalogic strongly recommends a minimum 24 VDC supply voltage when using a

master/slave configuration.

The power consumption of the different DS6300 models is slightly different.

In particular, when connecting several DS6300 readers in a master/slave connection, the

typical power consumption for each scanner is 15 W. There is a power peak of about

20 W lasting 5..10 seconds caused by the motor starting.

A security system allows the laser to activate only once the motor has reached the correct

rotational speed; consequently, the laser beam is generated after a slight delay from the

power on of the scanner.

Note that GND is internally connected to chassis. The cable shield is also connected to

pin 1 - CHASSIS.

DS6300

USER INTERFACE

23/25

GND

V- (Ground)

V+ (15 – 30 Vdc)

9/13

CHASSIS

Earth Ground

Chassis

Figure 45 – Power Supply Using the 25/26-pin Connector

2.4 USER INTERFACE

RS232 PC-side connections

9 6

9-pin male connector

25 14

25-pin male connector

Pin Name Pin Name

2 RX 3 RX

3 TX 2 TX

5 GND 7 GND

7 RTS 4 RTS

8 CTS 5 CTS

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 104 105

Brak uwag

Datalogic Laser Barcode Reader DS4600A-2XX5 Instrukcja Instalacji Strona 48