Datalogic DL Cordless Card DLCC Instrukcja Użytkownika Pobierz pdf (Strona 9)

INSTALLATION

2 INSTALLATION

2.1 INSTALLING DL TCL™ ONTO THE TERMINAL

Once the DL Mobile Configurator™ Enterprise 2 has been installed (see relevant

manual), it is possible to set and configure the DL TCL™ application and download

the related files onto your terminal.

Figure 3 – DL Mobile Configurator™ Enterprise 2 Main Window

For a correct and complete downloading, you must define the parameters available in

the configuration tree. In particular you must set the “Download Selection” parameter

to DL TCL™ for downloading this application.

Once you have set all the parameters required by your DL TCL™

application, it is

necessary to enable the communication between the DL Mobile Configurator™

Enterprise 2 and the terminal by following one of the procedures given below:

- Connection through the RS232 port:

From the DOS prompt run the command DS [Bx], where x is one of the following

baud rate speeds:

5 = 9600 bps

6 = 19200 bps

7 = 38400 bps (default speed of the DTPS communication protocol)

8 = 57600 bps

9 = 115200 bps (default speed of the DL Mobile Configurator™ Enterprise 2)

- Connection through Cradle:

Extract the terminal from its cradle, then, from the DOS prompt run the

command DC [Bx], where x is one of the following baud rate speeds:

5 = 9600 bps

6 = 19200 bps

7 = 38400 bps (default speed of the DTPS communication protocol)

8 = 57600 bps

9 = 115200 bps (default speed of the DL Mobile Configurator™ Enterprise 2)

After setting the required baud rate, insert the terminal back in the cradle and

the message “Start Server...” will appear on the display.

Configuration Tree

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 61 62

Brak uwag

Datalogic DL Cordless Card DLCC Instrukcja Użytkownika Strona 9