Datalogic QuickScanQS6500BT Dokumentacja Pobierz pdf (Strona 104)

Symbologies

6-16 QuickScan

QS6500/QS6500 BT

UPC-E — continued

UPC-E Data Group Characters

Once you’ve pre-set your desired Data Group Characters

using the Data

Group Characters

feature found in Chapter 5, Data Editing, you can choose

to output up to two of those pre-sets whenever a UPC-E bar code is

scanned.

To set this feature:

1. Determine which Data Group pre-set(s) to output. You can select

up to two from the following:

Data Group 1 * Data Group 2 * Data Group 3 * Data Group 4

For example, your choice might be Data Group 2 only; Data

Groups 1 and 3; Data Groups 3 and 4; or no Data Groups.

2. Scan the START bar code to place the imager in Programming

Mode.

3. Scan the SET UPC-E DATA GROUP CHARACTERS bar code.

4. Turn to

Appendix B, Alpha-Numeric Pad and scan the digits repre-

senting the Data Group designation(s) chosen in the first step

above. A digit of value zero (0) selects “no group.” For example,

scanning 3 and 0 would output only the character(s) set for Data

Group 3 whenever a UPC-E bar code was scanned. Scanning dig-

its 1 and 2 would output both Data Groups 2 and 3. To select no

Data Groups at all, scan 0, then 0 again.

5. Scan the SET bar code to accept the digits scanned.

6. Scan the END bar code to exit Programming Mode.

1. In that chapter, you can select which character(s) and position(s) to place Data Characters

within scanned data output.

NOTE

The options in this section set Data Group Characters

for the UPC-E symbology ONLY. If you wish to enable

this feature for additional symbologies, turn to the

options in the section specific to the other symbol-

ogy(s).

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 335 336

Brak uwag

Datalogic QuickScanQS6500BT Dokumentacja Strona 104